Forced induction will never feel the same again when you use the new screw blower snout from RCD Engineering. No more failures, just all-out performance that doesn’t add lots of weight to your setup. See more details below.
Official Release:
RCD’s newly designed lightweight Screw Blower Snout utilizes a 24 tooth top fuel blower snout shaft. The front drive coupler runs through the snout and engages the rear drive hub, eliminating the intermediate quill shaft that’s prone to failure. The front starter jaw uses a 1/2 inch square head, allowing use of a 1/2 inch ratchet, instead of the older 3/8 hex to turn the motor over.
Features:
- Weighs only 4.15 lbs
- Optional heavy duty belt guard 103507-0062
- Optional side guards both for left and right side of blower motor