Well to fast forward a bit. Things here have been BUSY to say the least. Comp Cams sent over a set of Magnum Steel 1.5 Roller Rockers, Push Rods, Billet Timing set, 3 piece cover and retro hydraulic rockers with the factory spider. Zex sent over a plate kit and TCI a Rattler Balancer. We were doing cam testing with 3 nitrous cams and 1 NA. Top horsepower off nitrous horsepower was 523 HP and top nitrous run was 702 HP. This was done on the Dart assembled SHP short block and 215cc as cast Pro 1 top end kit. Westech assembled the top side of the engine and dynoed it. The Holley 4150 HP 830 CFM carb performed flawlessly as there was no adjustments needed out of the box and the motor was ran on a conservative air/fuel averaging about 12.2:1 NA.
Next, the engine will go over to Mckinney Motorsports where they will fabricate some mounts and modify the front sump oil pan. Check out the video below.
You might also like
FuelTech’s New FT470 ECU Packs Big Features For Under $1,000
FuelTech's new FT470 ECU is packed with new features. The FT470 is FuelTech's first ECU that doesn't come with a built-in display.
